Got a New GPS Speedometer from Speedhut
With the Right Options Picked, it Looks Almost Stock
Here's How I Fit it in the Stock Pod
First Step Remove The Column Cover
Next Pull the Dash Cover (If You Have One)
The Speedo is Held in by Two Wing Nuts
Almost Impossible to Get Off by Hand
Easy Removal is Done Via a 3/4" Socket
Boom
With the Dash Cap Out of the Way
And
The Two Wing Nuts Removed the Speedo Slides Out The Front of the Dash
Disconnect the:
Gauge Lights
Trip Reset Cable
Speedo Cable
& Remove Speedo
& Remove Speedo
Now Get Ready To Disassemble the Speedo
Remove the Four Screws Holding the Gauge Shroud to the Gauge Body
Compare Gauges
Old vs New
Looks Pretty Similar
Looks Pretty Similar
Carefully Remove the Guts of the Gauge
Retain the Gauge Body
Insert New Gauge into Old Gauge Body
Slide New Wires Through the Rear of the Gauge
Use Old Gauge Shroud to Stabilize New Gauge in Gauge Body
Wire Up Per Instructions
Place GPS Antenna in Your Ideal Location
I Put It on the Metal Dash Valance w/the Defrost Vents
Finished Product
Same Install Method for Install of Tach
No comments:
Post a Comment